|
Farmall & IHC Tractors Discussion Board |
Page post on HP torque
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Aces on March 24, 2006 at 11:49:36 from (65.54.98.103):
Kevin had a good post about HP and torque. It will compute out on paper every time. But I don't think the ricer would ever do the job of say an 806D. The only way to get torque is with cubs. Take like a one ninty XT ac at about 305cid and a 966 with 414cid the 190 will use less fuel than the 966 but when it gets tough going the 966 will out work the 190. Or a 560 282 with terbo at 100hp an 806361 will out work the 560. It takes cid to do work, or like the new 4.7 v8's in pickups, I got a 4.7 dodge with 245HP my 96 with 318 and 225 would run all over the 4.7 and better milage with the 318. So what works on paper not always the way things play out.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
