Farmall & IHC Tractors Discussion Board |
Re: More Dangers of Tractors and Stupidity
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on April 15, 2006 at 04:09:40 from (216.208.58.178):
In Reply to: More Dangers of Tractors and Stupidity posted by PAULIH300 on April 14, 2006 at 17:52:22:
Paul: It is rather unfortunate that a tractor gets the rap when something like this happens. I remember one Sunday afternoon about 35 years ago, a neighbor sent his 16 year old son who worked for me, to borrow my tractor with loader for his dad. I said sure, really never asked why or what they were going to use it for. Well, my curiousity got the best of me, thus I walked through 7' high corn to see what stupid thing his dad did to require a front end loader on a sunny Sunday afternoon. I might have guessed, his dad got the notion the rear wheels on his Pontiac should be on opposite side of the car. He had jacked one side with bumper jack then placed blocking under that side. He then had put bumper jack under other side, and at the point he had both wheels off, the car went sideways and to the ground. Luckily no one got hurt. He needed the front end loader to pick the car off the ground again. A few years later this same individual decided to change a U joint in his pickup drive shaft. Hadn't chocked wheels or even applied park brake. As he took the joint apart the truck took off with him under it. He grabed the frame and hung on until the truck stopped. Luckily, nothing more than scraps and bruises this time. He's kind of like the cat with 9 lives, except in his case it must be 99 lives. He's now about 83, I think I could write a book if I told all about him. The worst injury he ever sustained was a broken leg, and that happened breaking wild horses. Some folks are just an accident looking for a place to happen. It's unfortunate they ever use tractors.
Replies:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|