Farmall & IHC Tractors Discussion Board |
1066 Steering Cylinder
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Michael Sheik on April 20, 2006 at 05:29:06 from (199.153.205.246):
I was replacing the tie rod end on left side the other day and noted that the steel block with anchor pin on the end of the steering cylinder has approx. 3/32 play between O.D. of pin and I.D. of steel block. I was considering machining the block out and installing a bushing but when I cleaned off all the grease and dirt, I can see what looks like a bushing already in there. Was this bushing installed at factory or was this a repair. Actually, kind of glad to see the bushing as I will not have to machine out block. I am also sure there will be some wear on O.D. of shaft. I could build up with powder torch and machine back down but am afraid the heat will make shaft brittle. What do you all think? One last question! I have not attempted to pull the pin yet. I can see the cotter pin on bottom of shaft but shaft is awfully tight in its hole at present and wandering if it is press fit, screwed in or just rusted in there over time.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|