Farmall & IHC Tractors Discussion Board |
Re: Lucky Guy(i think)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by captaink on April 21, 2006 at 07:53:45 from (66.115.214.56):
In Reply to: Lucky Guy(i think) posted by SDE on April 21, 2006 at 06:55:56:
Make sure that everything from the air cleaner to the valves is clean and doesn’t have any thing hiding in it. I’m sure there are plenty of those experiences around. I for one had an IH 345 drop a valve and pretty much destroy the engine. I found a different one and rebuilt it but (for some reason I don’t remember why now) decided to use the manifold from the destroyed one. I fired the engine up and it had a knock in it. Finally it started to miss, so I pulled the spark plug out and the electrodes were bent shut. Off came the head. On top of the piston was a chunk of aluminum which had finally imbedded itself next to the cylinder wall and later I found it to have crushed a ring land. Off came the pan and a new piston went in to replace the damaged one. Fired it up again, and it ran fine for about 15 minutes and it started to knock again then miss. Pulled the spark plug out (this time one the other side) and another spark plug was bent shut. Off came that head and the same deal, only this time the piece was still floating but again the pan came off and another new piston went in as it was dinged up pretty badly. The intake also came off and got cooked, baked, high pressure washed and anything else I could think of to make sure that was the LAST piece of crap in it! Diagnosis was that there was junk in the intake manifold from the piston breaking up when the valve went on the original engine. I had cleaned the intake and was sure there was nothing in it…well captain obvious tells me that it wasn’t clean, and the schooling cost me two pistons and a lot of labor.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|