1Point Rotary Cutter for Farmall 100 Questions

Posted by VinnieNC on May 01, 2006 at 03:49:36 from (12.174.171.101):

I am looking for a Rotary Cutter for a Farmall 100. I have seen a couple different designs and was wondering which works best. Some look like 3 Point hitch models that were modified to weld on the single point. Some have the input shaft of the gearbox straight toward the tractor and some have it angled toward the PTO Shaft on the tractor. The angled gearbox seems like it would be easier on the U joints and drive shaft since one end would be closer to a straight line. Some models (Hardee) have two tailwheels, some only one. I would think with two tailwheels, it would be more stable. From my research, it looks like an Overrunning Coupler is recommended. Any thoughts, suggestions or hints from those in the know?
Thanks.

-Vinnie

Replies:

• Re: 1Point Rotary Cutter for Farmall 100 Questions Nat 2 10:53:46 05/01/06 (0)
• Re: 1Point Rotary Cutter for Farmall 100 Questions Hobo,NC 05:00:56 05/01/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]