Farmall & IHC Tractors Discussion Board |
Re: Displacement on Demand
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by oliver fan on May 10, 2006 at 21:48:38 from (69.11.148.18):
In Reply to: Displacement on Demand posted by AgED on May 10, 2006 at 21:09:52:
AgED, I don't have any experance with those engines in farm tractors, but I drove a IH truck that had about the same engine in it. I think the cubic inch was 550. I know IH had a 549 gas burner and I think the diesel was 550 C.I. Anyway, I know it would fire on 4 cylinders while sitting at a stop light, etc, but when you would take off, or put it under full power it would fire on all 8 cylinders. As for power, it lacked a lot. The truck (tractor), trailer and load weighed about 58,000 pounds, if I remember right. A good running 348 Chevy V8 or a 351 G.M.C. V6 or a IH 345 V8, would run circles around that IH Diesel, with all of them weighing the same.
Replies:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|