Farmall & IHC Tractors Discussion Board |
Re: 826 diesel hydro drive starter prob
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Weldon K on May 13, 2006 at 18:58:20 from (71.30.103.243):
In Reply to: 826 diesel hydro drive starter prob posted by The Rancher on May 07, 2006 at 20:07:49:
Assuming that an 826 Hydro has same starter wiring as 06 and 56 series tractors (it should),and that you simply removed the wires from the starter and not from everywhere else behind the dash, then the fix is simple. The wires with the large eyelet connectors and the battery cable (from the positve post on battery), connect to the large stud on the left side of the solenoid. ( The other large stud to the right should have a flat metal strap connected to it with the other end of it bolted to the side of the starter housing.) The wire with the small eyelet connects to the small stud on the upper right side of solenoid ,(just above the large stud with the flat metal strap attached to it). The remaining small stud (just below the large stud on the left) has nothing connected to it.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|