|
Farmall & IHC Tractors Discussion Board |
Super a governor remove
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Steve Santini on May 14, 2006 at 12:41:06 from (69.26.10.80):
Hello All-I need to remove my governor to check springs and wts. My manual from Binders doesn"t really give a "removal" direction. Can anyone tell me if the governor can be removed from the radiator side (4-5 bolts holding housing on) witout bothering mag and timing? Will I need to watch fo the old "flyng parts"nightmare when I remove the gov. via th cover/housing I am describing from the radiator side?
I did go thru archives, couldn"t really find my answer.
There are some posts about making sure pts are open and #1 is at tdc and don"t turn the motor when pulling mag-but is taking the gov. off the back side of the mag/timing unit going to affect the timing gear ect. if nothing is turned?
Thanks in advance for any input. Steve in ND
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
