Farmall & IHC Tractors Discussion Board |
Re: M magneto
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ole' Farmall on June 12, 2006 at 12:22:57 from (152.163.100.65):
In Reply to: M magneto posted by Ole' Farmall on June 11, 2006 at 17:25:05:
There is a place where a wire goes on the side.On the MAG. It connectes to the swich where you filp to to start it. and the other wire that comes off the swich goes up to the box where your light swich is. The coil is like a black small tub probly 3 in long and 2 in wide and it sticks out the top. Thats where i unsrewed the 4 screws and i guess thats the winding in there and thats what melted. I toock the distruibtor off the 350 but did not thave time to see if it fits the m also the H is 6 volt and pops wants me to get that running something draws the battery dead whn you put the positive cable on. The M is a 12 volt
Replies:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|