Farmall & IHC Tractors Discussion Board |
Re: farmall H not getting gas to plugs
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on June 15, 2006 at 07:49:04 from (66.173.50.150):
In Reply to: Re: farmall H not getting gas to plugs posted by F250 on June 14, 2006 at 11:33:31:
I still do not know if the tractor was running recently, or how/when it stopped. The details are important to diagnosis. If there is fuel to the carb (meaning that if you put a can under the carb with the bowl off of it and turned on the fuel at the tank, fuel would come out the needle/seat in a stream 1/2 the size of a pencil for 2 minutes). If so the jets in the carb could be pll plugged up. Carb cleaner and a rebuild kit would repair that. Clean every passage and blow out with air. To see if it is a fuel problem, pull the plugs and use a pump oilcan to pump one squirt of fuel in each cylinder then replace plugs and try to start. If it does then stops, it is fuel, and the carb needs to be serviced. JimN, Please start a new entry topic as this one is getting lost in history. THanks
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|