Farmall & IHC Tractors Discussion Board |
806 help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by FC Andy on June 21, 2006 at 13:08:51 from (216.68.248.2):
I tore apart my brake housing to replace some seals today (I"m hoping to seal all the leaks to get around to paint it) and while I had everything apart, I decided to see if I could chuck the Bull pinion shaft. Well, it chucked, about 1/8 of an inch i"d roughly guess. I need to put a dial indicator or it to really know. My point is, How much can a person allow? I"ve been driving it around occasionally since I got it running this spring, and it dosen"t drive funky with any kind of jerking or anything else. The IH book only says to check and repair bearings to set standards but dosen"t list any. And, if I should replace them, do I have to tear the Axle housing off to do it? The book makes It look that way. My hour meter only reads about 4600 hours, that"s low compared to some I"ve heard of on the internet and in books. Of course, I don"t know how many times It"s rolled over. Are there other 806"s out there just as worn out or worse still goung strong with no problems? Or is this something I should be really worried about? Taking the rear axles off to replace the worn bearings on the bull gear shafts just about committs me to a rear end overhaul. I"m scared to find out what that will cost. I need some guys with lots more expirence than myself to explain this one out. Thanks so much. Andy
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|