Farmall & IHC Tractors Discussion Board |
Re: F20/F30/M
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Guy Fay on June 28, 2006 at 19:50:04 from (24.177.121.73):
In Reply to: Re: F20/F30/M posted by CNKS on June 28, 2006 at 18:08:56:
The F-30 had several problems according to IH, mainly: 1. Low power to weight ratio- it was heavy for the HP, which lead to: 2. High cost- IH was putting a lot of iron into the horsepower range, tractors essentially are coseted out "by the pound". This led to: 3. Low sales. Sales were only about 1/5th of the F-20 (@30,000, compared to 154,398 for the F-20, and @147,000 for the F-12/14), which fed back into cost, of course. The F-30 did have some things going for it- high crop clearence, strong drivetrain (helped somewhat by that low power) The way to eliminate the high weight, low horsepower, was to go to an F-12 type chassis in the F-20 size, and stick a big motor in front of it. While the M did start out as the F-20 engine with the F-12 type chassis scaled up, the sales department sent it back several times for revision, mainly to get power up and weight down (in fact, the sales department sent the tractor back several times for less weight, more power). So what you got was the M, which took the old F-20 and F-30 market, the H, which took the F-12/14 market plus some of the old F-20 market, and the A and B, which took IH into a whole new market, plus some of the low end F-12 market (the F-12 was actually a bit much tractor for the low end in the 1930s, and really, really got chased out of the low end by the Allis B. The F-12 was repositioned as a light 2 plow tractor by the horsepower increase with the change to the 14.)
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|