|
Farmall & IHC Tractors Discussion Board |
Re: 300 Transmission Noise
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by biggerred on July 01, 2006 at 10:03:14 from (12.8.252.204):
In Reply to: 300 Transmission Noise posted by Stu Red on July 01, 2006 at 05:56:02:
I just got my 300U broke in 3rds and found all the drive shaft bearings worn out,(between the clutch and trans) to the point you could press out the inner races. That old gal was real loud around the shifter area. I got all new bearings from Case/IH, and the price was not that bad either (SHOCK). I am however, still looking for a trans drive shaft for a non t/a tractor. Mine is VERY pitted where the transmission pilot bearing rides.
Replies:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
