Farmall & IHC Tractors Discussion Board |
Re: W30 magneto timing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KEB on July 03, 2006 at 11:23:28 from (207.94.27.3):
In Reply to: W30 magneto timing posted by Ben Sanders on July 03, 2006 at 10:16:08:
First, bring #1 cylinder up onto compression, and set to top dead center. Make sure the rotor on the magneto is pointing at the #1 spark plug terminal. Set the timing such that the impulse trips a little bit AFTER top dead center - if you set it to trip too soon, it'll kick backwards when you crank it. You make find adjustments in the timing by aligning the bolt holes in the coupler - they're spaced a little bit different on the two pieces so that the some pair will aling with small changes in the relative position. Running timing is set by rotating the cover on the end of the magneto (with the arm attached). Keith
Replies:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|