Farmall & IHC Tractors Discussion Board |
Re: Help Me Think
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on July 08, 2006 at 06:29:58 from (66.244.90.5):
In Reply to: Help Me Think posted by Allan In NE on July 08, 2006 at 06:09:53:
Allan, Although Im not much of an IHC man Id say loosing a head gasket BETWEEN two cylinders is a fairly common place to loose one as its a narrow thin seal going on there. If shes not white smoke steaming or blowing coolant externally sounds like its a pure blow out in that thin area BETWEEN two cylinders as you suspect. If you pull the head it may need sent to a machine shop to plane it down smooth in the event its warped or untrue. They can see if its warped or cracked etc at a machine shop. Maybe it was off at one time and didnt get toqued back down properly?? John T
Replies:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|