Farmall & IHC Tractors Discussion Board |
Re: Farmall B rear end and final drives
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Charles McNelly III on July 14, 2006 at 21:21:47 from (65.54.154.146):
In Reply to: Re: Farmall B rear end and final drives posted by scotty on July 13, 2006 at 07:51:34:
I just finished replacing all 7 seals on my Farmall B. There is the outer seal on the lower axle, a seal on the side of the transmission housing, a seal on the front of the transmission, and a seal on the upper axle where the tube bolts on. Here are the part #s. You will need two 288864R3, two 71597C91, two 71697C1, and one 381907R91. These are Case/IH part numbers. They cost me $135.93 for all 7. You might be able to cross these numbers with someone else to get the price down. Good luck, Charles
Replies:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|