|
Farmall & IHC Tractors Discussion Board |
Please help, putting a SUPER M together, have ?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BrianM123 on July 16, 2006 at 14:56:03 from (68.43.112.98):
Hello all. Friend & I are assembling a Super M back together. I have a few questions. First we turned the engine over to prime the oil system. Oil cam up through the rocker shaft just fine. I noticed no oil came up through either of the two feeder holes for the cross over tube. I'm assuming the engine needs more RPM than the starter can provide to push oil through, am I correct? Also, what is the purpose of that cross over tube. It has one small hole drilled into the tube just above the exhaust rocker for No. #1 cylinder. It has me thinking this is an oil feeder for the rocker/valve area? Last, can we have the generator rebuilt to 12v specs? If not what might work in it's place other than those Delco conversion alternators? We want to keep it stock looking. Is there a 12v regulator made? Thanks for any help.
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
