Re: Farmall wheel weights

Posted by Hugh MacKay on July 17, 2006 at 02:05:04 from (216.208.58.192):

In Reply to: Farmall wheel weights posted by mitchp on July 16, 2006 at 21:00:26:

Mitch: According to the IH operators manual you need 4 - 5/8" N.C. x 3-3/4" for the pressed steel wheel and 4 - 5/8" N.C. x 5-3/4" for the cast wheel. Those are carriage bolts and do not need to be grade 8. They do recommend lock washers.

I couldn't believe my luck last week. Went to our local Antique show, which hosts a large number of flea market vendors. Marg. wanted to go and I told her I was looking for manuals and wanted to be there early before items got picked over. We were and within 5 min of walking through the gate, I had an original IH 140 operators manual, an IH Blue Ribbon 140 chassis servive manual and a manual for my 1 point fast hitch disk harrow.

Three books and all in excellent condition. Watch the summer time antique tractor shows with flea market items, folks. It can be very rewarding.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]