Farmall & IHC Tractors Discussion Board |
Wire Brushing Old Iron
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by EUG1206 on July 21, 2006 at 04:43:36 from (71.39.101.114):
I have done my version of a restoration of a Case SC that has been in my family for 60 years and am now going to begin my second project. I do the work in my 3 stall garage attached to my house. My wife has concerns when I wire brush the old iron and the harmful effects of lead based paint dust. My goal has always been to clean up and smooth out as much as possible but not a professional job equivelant to sand blasting. Is there still a danger with lead based paint dust? If so is it a minor issue or a major concern? we do have two kids, ages 7 & 10. Any comments? Advice? My next project is a 300 Farmall by the way.
Replies:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|