Farmall & IHC Tractors Discussion Board |
hydraulic pump quit?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gary In Mozarks on July 21, 2006 at 06:53:22 from (64.240.21.173):
After several months sitting, I finished up another project and got back to the Farmall 460D I rebuilt the starter and got it running again. Wed night I mowed about 3 acres of grass hay, then had to quit because the hydraulics went out. No steering, no lift on the Farmhand F-11 loader, no three point. I took what little hydraulic fluid I had on hand out there (a gallon or two) and it worked enough for me to get the tractor back to the shop. I figured the fluid was low from sitting. Today I put 7 gallons of fluid in it and ran the bucket up and down a few times, then nothing. I replaced the filter back last year when I learned the lesson about not taking the TA off going down hill (DUH) I got the IT manual out and I am looking that over. I guess I will start by pulling the filter again. Any suggestions?
Replies:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|