Farmall & IHC Tractors Discussion Board |
Re: Need a little help with 400 farmall
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on July 23, 2006 at 07:05:12 from (66.173.50.166):
In Reply to: Need a little help with 400 farmall posted by J Muehring on July 23, 2006 at 05:53:15:
The nut holders are usually delt with by akward efforts to ger behind the panel to hold them. If not twisted off, using a piece of 1/4" masonite with a 5/8" hole in it to protect the tin, weld a 1/2" (wrench size) nut to the top of the round head screw. The heat of arc welding the nut in place will likely free up the threads. If twisted off, they are easier to fix. Remove one side of the sheet metal retainer and replace the nut, then reshape the flap and braze it in place. (be careful not to distort the metal with heat on the surface tin. Use permatex brand anti-seize compound on the new threads to prevent further grief. JimN
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|