3 pt cylinder wont work

Posted by Terry Miller on August 04, 2006 at 03:54:30 from (208.134.202.54):

I have a 300 ute and the 3pt cylinder ram was previously bent and cracked at the yoke on the end. It broke and had to replace the cylider with a used one I found for $50. I installed it and at first it did not want to work but finally did slowly. Then it had a chatter up and down. Now it is not working at all. The two steel lines that return to the pump were leaking at the o rings in front and we replaced those, and there was also a small pin hole at the back where they enter the housing below the seat. I had them welded twice but they still leak there. Does this have anything to do with the ram not working? It seames like the pump has lost its prime. I cant get the set screw on top of the pump to budge, was going to pour some fluid in to prime it. The fluid level is also full. NOW WHAT? Terry

Replies:

• Re: 3 pt cylinder wont work jossette 18:05:41 08/05/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]