Farmall & IHC Tractors Discussion Board |
Re: carb float setting
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mikey D on August 08, 2006 at 18:21:42 from (68.221.170.10):
In Reply to: carb float setting posted by Norm/NiagaraFals/Canada on August 08, 2006 at 17:18:39:
Here are the specs which came with my NAPA rebuild kit: Series 63: 1 + 5/8" Series 63M: 1 + 19/32" Series 61-67-68-161-267: 1 + 5/32" Series 263M: 2 + 1/64" (Look at the tag on your carb for the series #.) For my 1953 Super A, it was 1 + 5/32". It was also 1 + 5/32" in my IH SA Service Manual. However, that did not work. At best, it ran rich; at worst, it flooded out. I had to set it at almost 1 + 1/4" in order to get it to run lean enough. It ran like a dream after that. In my 140 IH Service Manual, it lists all 123 engines equipped with Zenith carbs at 1 + 5/32". Mike
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|