|
Farmall & IHC Tractors Discussion Board |
Re: m or 400
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave Slater on August 18, 2006 at 06:00:48 from (205.188.116.133):
In Reply to: m or 400 posted by adam jones on August 18, 2006 at 03:06:38:
Just a few things if you have a complete farmall 400 engine. Crankcase vent pipe comes out top of valve cover on 400 and back of head on M. You can use suitable rubber hose to modify that. Governor throttle lever arm will be different.Take lever out of M and install in 400 or put M governor complete on 400 engine. 48 M has a 11 inch clutch,if thats what you use put the M flywheel on 400. If you use the 400 flywheel it takes a 12 inch clutch set up like SM or late M. 400 clutch plate is wrong splines. If you use stock 48 belly pump you have to use 11 inch clutch because they changed front case on late M and SM to clear 12 inch. Distributor drive that bolts to front cover on 400 is different bolt pattern than 48 M. If your going to use one and not the hydraulic pump find one with a 6 digit # ending in RI from SM or some 1950 M and newer.
Replies:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
