Farmall & IHC Tractors Discussion Board |
Re: Farmall Super A transmission oil leak
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by banjo on August 18, 2006 at 19:40:05 from (65.67.203.13):
In Reply to: Farmall Super A transmission oil leak posted by jf1000 on August 18, 2006 at 15:44:41:
You are correct in how to get at the seal and replace it. the shaft will go back in pretty easy if you decide to pull it all the way out. Just don't mash the clutch and let the clutch plate get out of line. you will have to pull it far enough forward to pull the flange from the tranny to replace the seal. the spline will be out of the clutch when you get the tractor split to seperate the flange so just give yourself enough room to work.
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|