Farmall & IHC Tractors Discussion Board |
Bore Clssification
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by TiptonJack on August 22, 2006 at 16:37:28 from (205.188.116.133):
Just read an older post that some of the more distinguished members of this forum commented on, and as it will soon pertain to my rebuild, I wanted to try to get some clarification. One said that aftermarket sleeves will only fit A-B classification bores, and you must have C-D bores machined to A-B. I didn't know you could make one smaller, but that just goes to show my inexperience. Another said you can get after market sleeves in the right size for either, you just have to specify when ordering. I also heard that as long as they aren't D's, the sleeves will fit. As I've almost got enough $ saved up to make that call and order my kit, I need to know because mine are are B's and C's. Thanks fellers
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|