Farmall & IHC Tractors Discussion Board |
Re: 1256/1000 PTO
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by K.B.-826 on August 23, 2006 at 16:45:06 from (66.188.194.44):
In Reply to: 1256/1000 PTO posted by GeoM0 on August 23, 2006 at 14:44:31:
The 1000 RPM PTO unit was all you could get from the factory on the 1206, 1256, and 1456. IH figured that the 540 RPM implements of the day couldn"t handle all of that power. Most dealers ordered those tractors with no PTO unit at all and then ordered a 540/1000 unit through parts and installed it. You"ll need a complete 540/1000 unit if you wish to convert, and that will probably cost more like $600. Check your baler"s manual, most round balers can be converted from 540 to 1000 fairly easily.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|