Farmall & IHC Tractors Discussion Board |
Re: Ih 574
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fromjb2 on August 30, 2006 at 17:04:32 from (69.198.143.165):
In Reply to: Ih 574 posted by Bob Lang on August 30, 2006 at 14:59:03:
Hi Bob, do you mean the rockshaft arms at the back of the seat or the 3pt lift arms? If it is the 3pt lift arms maybe the roll pin that locks the leveling yoke in the leveling screw housing in the non float position is missing or broken. The roll pin with a locking key goes in a hole in the levelling screw housing just above where the levelling screw housing attaches to the 3pt lift arms. When this roll pin is removed it allows the 3pt lift arms to float independently. We used to pull these roll pins when we used the tractor on a 3pt corn planter so if a rear wheel dropped in a hole the other end of the corn planter would not come out of the ground. Hope this helps JB2
Replies:
Home
| Forums
Today's Featured Article -
New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|