|
Farmall & IHC Tractors Discussion Board |
Re: F12 can't get 'er to start fer nothin'
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on September 06, 2006 at 06:01:55 from (64.12.116.65):
In Reply to: F12 can't get 'er to start fer nothin' posted by holt_2ton on September 05, 2006 at 16:19:47:
Make sure your plug wires are copper wire and aren't the resistor type wires. Bring No1 piston to TDC on the compression stroke and then remove the cap from the mag and see where your rotor is pointing. Should be at the No1 plug tower. If it is, remove the coil wire from the cap and hold within 1/8-1/4" of a good ground while someone hand cranks the engine. Should have a hot blue
spark. You may have a weak coil if the spark is weak or the magnets may have lost some of their magnetism. Hal
Replies:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
