Farmall & IHC Tractors Discussion Board |
Re: WD6 value?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on September 06, 2006 at 10:32:48 from (152.163.100.65):
In Reply to: WD6 value? posted by paul - iowa on September 06, 2006 at 04:58:05:
The tractor's sheet metal appears to be fairly straight even though it doesn't appear to have been shelted over the years. The rear tires appear to have decent tread, hard to tell if they're weather checked. Needs front tires too. Are you allowed to drive it before submitting a bid? You won't know if the clutch or transmission is in need of repair. Are the tractor's maintenance records available? These would be helpful in determining how much you want to bid. Having the engine running is a plus, but it may still need a complete overhaul unless the town redid the engine since they've had it. A man in Ohio just restored a Super WD6. I don't know if he had originally owned the tractor or had bought it from someone and had decided to restore it. He had the tractor completely disassembled and found a lot the bearings worn out. I have a picture of it after it was restored. I had some that were taken during the restoration, but I must have deleted them. I can email you a picture if you want to see it. I bought a Super C for $700.00 that ran good, but needed u-joints on the steering. It had almost new tires front and rear. I replaced the worn u-joints. It needed a paint job too. The sheet metal was very good. Tractors may be higher in your area so you would have to be the final judge on that. I think somewhere in the $700 to $1000 range. Very easy to invest $4000 to $5000 in these tractors with a complete engine overhaul, clutch, tires and painting. Hal
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|