Re: Cub Clutch Pressure Plate Problem

Posted by Merlin on September 07, 2006 at 16:42:10 from (209.205.158.217):

In Reply to: Re: Cub Clutch Pressure Plate Problem posted by foxprints on September 07, 2006 at 14:19:40:

Just went through this last week. The guys on the Cub board helped me through it. To measure the 1 1/8" to 1 1/4" to the plate while still in the tractor, I bent a small stiff wire to 90 degrees with the short end being 1 1/4" long. I then put it in beside the fingers to see the measurement. If I needed to adjust it, I took a 1/4" ratchet with a 1/4" socket and put a flat screwdriver from a drill motor set in it and loosened the nut and held it with the 1/2" wrench and ratcheted it into adjustment.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]