Farmall & IHC Tractors Discussion Board |
Re: Tank Heater Placement On 806D
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on September 08, 2006 at 00:55:11 from (216.208.58.189):
In Reply to: Tank Heater Placement On 806D posted by Harlen Larson on September 07, 2006 at 21:02:28:
Harlen: I think I'd stay away from heater hoses, I'd be afraid the heated coolant would circulate up to the heater and back, and not go to block until it cooled substancially. I'm not familiar with the 806 block. The 282 in the 560, 656 and 706 was an ideal candidate. I had two of these and hooked between block drain and a port in the head, about half way back the engine. The 282 has a port above each injector on the head, that goes into coolant chamber. This put the hottest coolant right in the head next to the ignition point. From there it circulated down through block and back to heater. My heaters were 1500 watt and I could plug them in 2 hours at -30 and it would be just like a summertime start. I've seen the block warm, and both heater hoses and radiator both still cold. I did my 404 Deere the same way, and all three worked very well. These tank heaters do have one downfall, they rust out after 6 to 10 years. I went to plug my Deere in one morning and most of the coolant was on the ground. It may not have been the heaters fault, it did have quite a dinge on side of tank, which probably took years off it's life. The heaters on my 282s actually lasted longer, but probably didn't get used as often.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers WD45 (Gas Version) - by Staff. Beginning production in 1953, the WD45 had the same general look as the WD tractor which was produced earlier - but was much more powerful. This was due to the new 4-cylinder "Power Crater" gasoline engine with a 4 x 4-1/2 inch bore and stroke. Some people feel this was one of the most significant tractors offered by Allis-Chalmers in those days. Nothing in its weight or power class could match its performance. In 1954 they began offering the WD45 with the new "Snap-Coupler&quo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|