Farmall & IHC Tractors Discussion Board |
Re: Exhaust Manifold - Somewhat OT
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill46 on September 20, 2006 at 09:28:32 from (63.65.68.246):
In Reply to: Exhaust Manifold - Somewhat OT posted by Michael Sheik on September 20, 2006 at 04:55:07:
On the ones I can get to, I usally take a 2" piece of flat metal, drill a 3/8" hole in it and lay it aganist the nut or bolt. Use an arc welder as it helps knock the rust off inside where the threads are. When everything cools off...bend the metal a little...maybe 15 degrees for a little off set...once it moves...spin the bolt right out. Did all the fender bolts this way trying to remove the broken fender bolts from a 450D. They had been broken off for years when dad took the fenders off. The things came right out.
Replies:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|