|
Farmall & IHC Tractors Discussion Board |
M Trans Coupling Help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by terryjd98 on September 24, 2006 at 11:21:18 from (69.159.71.205):
Hi, I posted a couple of days ago about trying to get that little odd shaped 4 bolt hole coupling that goes on the trans to the clutch shaft. After about 20 hours of trying no way can I get that coupling on. It goes up into place but when I try to put the 2 bolts in that goes in the coupling to the clutch end of the shaft the bolts hit the end of the trans housing so no way will the bolts go in. Using the old washers so clearance with them should be ok. Have turned the coupling every which way.
I seem to have the shaft that goes through the clutch to the flywheel that the coupling attaches to in as far as it can go. The trans end has never been moved so that should be ok.
Would anybody have a picture or something showing how that coupling goes on or of it on and in place? Maybe something showing the measurements of the space from the trans to the clutch shaft? They say a picture is worth a thousand words but I will take any help of any kind I can get.
I am about ready to take a hammer to it and junk the tractor new clutch and all lol. Spent too many hours on my back playing with it now.
Thanks for any help anybody can give me
Terry
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
