|
Farmall & IHC Tractors Discussion Board |
F12/F14 physical dimensions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Doug in Illinois on October 07, 2006 at 16:33:14 from (207.144.241.249):
Does anyone have the width of the F series tractor with wheels set at their narrowest? Also, the height at the tallest point.I need to go back to Nebraska and get what was my grandfather's F12 or 14?? Will have to check serial number tag, don't remember which it actually is as there are gas tanks for it with either number on it. Back then was easier to just get a used tank than repair a leaking one.Would really hope rear wheels will measure out at 68" or less, want to take a horse back there for my sister and don't feel comfortable hauling the horse on my dovetail trailer even if I enclose the horse somehow. My livestock trailer is a 6x24 3 axle, so the tractor weight is no issue.Thanks
Replies:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
