Farmall & IHC Tractors Discussion Board |
Re: Super H and NH baler question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on October 16, 2006 at 06:36:16 from (209.226.247.86):
In Reply to: Re: Super H and NH baler question posted by Marc ON on October 15, 2006 at 19:31:28:
Marc: I think he missed your point, if that thrower has hydraulic controls, yes by all means you need hydraulics on the tractor. The early NH throwers had a mechanical swing for the thrower, was just an arm from the thrower clamped to and allowed to slide on wagon tongue. It would probably be an easy conversion, the mechanical swing was quite a simple device, could easily be fabricated by a local shop. How far away from Strathroy are you? I had a thrower with mechanical swing, and if I saw it, could soon tell you how to overcome this. The mechanical swing throwers work fine on level ground. Side hills is where the hydraulic swing counts.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|