Farmall & IHC Tractors Discussion Board |
Re: Farmall H starter?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by williamf on October 18, 2006 at 01:52:51 from (69.19.14.18):
In Reply to: Farmall H starter? posted by Dairy Farmer on October 17, 2006 at 18:20:42:
It's almost certain that you're right. If it were the starter it wouldn't help to turn the engine a little. As Old said, it's really easy to pull the starter far enough to look in, just take the cable off and two bolts. I've got the same problem with mine for several years now and have gotten so used to it that I might wait until retirement to get around to splitting the tractor. I've got a hand crank (used from Steel Wheel Ranch, they're cheap) and every time I shut the tractor down I hop off and give it a slight turn. I tried dressing up the bad teeth with a Dremel but it didn't help. Wm
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|