|
Farmall & IHC Tractors Discussion Board |
Re: Crank Pulley Revisited
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Patrick Martin on October 19, 2006 at 20:02:41 from (64.154.26.250):
In Reply to: Re: Crank Pulley Revisited posted by EZ on October 18, 2006 at 19:25:04:
HEY! I just did this! What I did is I bead blasted the inside of the pulley and drove it on with a 3lb sledge and 4"X4" block of wood. A total of three hits. bump, Bump, BUMP,,,,, on it went! :) I think if you bead blast it, it will remove juuuuust enough to allow a good snug fit. be sure to use a bearing separator like shown in the manual or some other sort of backup behind the pulley to keep from breaking it on removal.
Replies:
Home
| Forums
Today's Featured Article -
Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
