Farmall & IHC Tractors Discussion Board |
KFOX
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by IndianaRed on October 21, 2006 at 07:07:19 from (205.188.116.133):
Hey Ken, I went and lost your email address again. Just wanted to thank you again for your help, and the parts. Was at the shop this morning and they measured my crank and it was really really bad. The journal that had the bad piston on it was worn 100 thous.! And one other would"ve needed welded too. Yours had none worn more than 3 thous., so yours is going in. The steering post will be going on too. I may want to get the hyd pump from you too, but you would have to let me pay you for that. Hope you"ve found your little miss problem. I read your post and the replies. Hope the one that said it maybe just needed run more for the rings to seat was it. Let me know how it"s going. Brian P.S. Here"s a link to those pics I took of your H
Replies:
- Re: KFOX Al L. in Wisc. 10:48:56 10/21/06
(0)
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|