Farmall & IHC Tractors Discussion Board |
Re: Anyone need to run drawbar pull on their tra
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on October 28, 2006 at 18:20:39 from (209.226.106.65):
In Reply to: Anyone need to run drawbar pull on their tractor posted by El Toro on October 28, 2006 at 13:51:47:
Hal: Could you test my SA? Seriously, I expect Nebraska have already exceeded those specs. Those new Deere and CaseIH, 8 wheelers will out pull a D8 Cat quite handily, on firm soil or agri tilled soil. I gave a D8 operator quite a surprise, this summer and I didn't have the largest 8 wheeler out there. He pulled me out of deep mud. He was driving on hard ground with me in tow, mainly to get rid of mud before we unhooked. I thought for the fun of it I'll step on brakes, I stopped him, he went for the heavy gears and rpm, I did the same and much to his surprise, he went for a backwards drive.
Replies:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|