Farmall & IHC Tractors Discussion Board |
Re: H4 Magneto Flooding problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by magman on November 02, 2006 at 02:32:30 from (67.142.130.15):
In Reply to: H4 Magneto Flooding problem posted by 772TAS on November 01, 2006 at 21:30:10:
NO its not a commpn ocurance. I would say that where your wire hooks to the condenser then goes through to the point chamber may need to be sealed. Try so Electrical tape in a can or like that. Also go to walmart and get a can ofclearcoat its called something glaze its in the spray paint section and is made for ceramics and such its about $3.00 Same brand as the rest of there spray paint it not special. When you done give it about 3 to 4 coats I think you will take care of your problem JON
Replies:
Home
| Forums
Today's Featured Article -
New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|