Farmall & IHC Tractors Discussion Board |
Re: Gas line valve
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jimer on November 15, 2006 at 19:15:53 from (198.174.213.58):
In Reply to: Re: Gas line valve posted by Janicholson on November 15, 2006 at 18:40:59:
I can't figure out how I would have room for a sedement bowl. There is only about 1/2" clearance from an imaginary vertical tube below the opening in the gas tank and the steering gear box. I suspect, the gear box has been changed. Seems I read that if the gear box had been changed and one from a different model tractor put it (think 350U?) it would fit but was larger then the original. Also, the gear box is in pretty good shape and this tractor had been used with a loader. I am tired or draining the gas tank on myself and elsewhere when I need to take the gas line off (which I am up against again as I need to get the starter out). Any ideas?
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|