|
Farmall & IHC Tractors Discussion Board |
auctiom results
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by pcy1066 on November 18, 2006 at 16:38:56 from (209.143.36.26):
ih 966 strait 34 inch rears good bit of blowby front had a lot of play strait sheetmetel and fenders motor sounded rough injecterleak 4750
1456 real nice wf good 38s on wedge locks 1000 pto only 10 100 lb fronts good 9 bolt hubs and duals 7750 probly best buy of the tractors
806 fast hitch m-n-w turbo wf snap on duals strait sheetmetel 5750
806 3 point dsl wf strait a little blowby snap on 38 duals 4450
720 5 bottom auto resets 850 nice
720 toggel trips real good shape 775
540 5 bottom good shape 325
915 combine running with big rice tires 1850
915 23,1 26 mismatched tires run good sounded good 1450
915 with 810 20 ft table 23,1x26 firestones ran it otta fuel coudent get it started back drove it 5 miles to a freind house sounded good,800
jd 336 wire tie bailor 4250
Replies:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
