|
Farmall & IHC Tractors Discussion Board |
Re: M pistons still stuck, what next besides a chi
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on November 19, 2006 at 20:55:51 from (4.244.57.160):
In Reply to: M pistons still stuck, what next besides a chisel posted by Skk on November 19, 2006 at 19:29:01:
Well first off what did you soak it with?? If you used PB, or WD40 then yep they will not come out. Now if you used tranny fluid and or turpentine and they still haven't come out then your going to have to bite the bullet and pull the engine and push from the bottom and even then the sleeves will probably come out with the pistons and then you will need new sleeves and pistons to ever get it to run again. And yes I have seen more then one crank broken before, never have figured out how they brake but they do
Replies:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
