Farmall & IHC Tractors Discussion Board |
Re: The Pitts
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Steven@AZ on November 28, 2006 at 11:10:22 from (216.67.213.217):
In Reply to: The Pitts posted by roger2021 on November 28, 2006 at 09:33:25:
If you want to get by really cheap, there are places that will sell you one sleeve and piston to replace the pitted one. We did it with our F12 when we restored it about 17 years ago. It probably has less than 50 hours on it since then, but needs to be taken apart and done right as it has a vibration from the mismatched piston, and poor oil pressure because we re-used the main and rod bearings. Do it right this time, just order an overhaul kit and put all 4 sleeves and pistons in it - along with new bearings.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|