Farmall & IHC Tractors Discussion Board |
Re: case loader on 784.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bernard le mécano on November 30, 2006 at 13:49:00 from (207.134.205.166):
In Reply to: case loader on 784. posted by Colleen Franke on November 30, 2006 at 10:08:05:
Hi, the 54,74,84,85,95,4000 series have one hydrolic pump. On the 84 serie, the flow is about 15 gpm, 12 gpm for the hydrolic system and 3 gpm for the steering. The steering circuit have a flow-divider valve to allow 3 gpm to the steering system. Check if the pressure is high on the remote by pulling on the remote lever, you can ear the relief valve open. Does the steering work ok? May be a bad relief valve, the flow-divider is stuck half in the hole or a bad pump. The best is to make a pressure test by the remote outlets with a pressure gage, about 2250 to 2500 psi at 1500 rpm. Bernard le mécano Québec Canada
Replies:
Home
| Forums
Today's Featured Article -
A Towny Goes Plowing - by Anthony West (UK). I live in an area renowned for its rural beauty. Small fields with hedgerows and trees are common place, as are small hamlets with village greens and the odd duck pond complete with swans. The center of any village once the shop is closed is the old tavern. Rustic places with cheerful names like "The Griffin" "Red Lion" or "The Plough and Harrow" are found dotted around the country lanes all over the place. The warm glow of yellowish light can be seen for quite some distance at dusk, and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|