|
Farmall & IHC Tractors Discussion Board |
Re: Lift All's
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by D Slater on December 06, 2006 at 10:22:40 from (152.163.100.65):
In Reply to: Re: Lift All's posted by BOBM25 on December 06, 2006 at 09:20:43:
Think I'm lost also. A complete aluminum IH style gas hydraulic pump like used on 6 series SM,SMTA,400,450 and some W series doesn't have the same bolt pattern to mount to front cover as a complete diesel pump for same series tractors. So if you do have a gas pump on your diesel something other than a straight bolt on has been done. The bottom 2 bolts that mount pump to cover are close togeather compared to gas. Do you have suction pipe from reservoir (rear hole)ending up to engine side or away from engine now? As other posted the original pipe was only used on lower production tractors SMD with factory live hydraulic, SMTAD and I think same pipe and block was used on some SWD6 and SWD6 T/A .
Replies:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
