Re: Need an internal gear for a 300 U hydraulic pu

Posted by Jimer on December 10, 2006 at 10:01:21 from (198.174.213.51):

In Reply to: Need an internal gear for a 300 U hydraulic pump posted by SKK -Big Red Fan on December 09, 2006 at 18:17:03:

I have a 300u and just went and looked at a new pump (I thought I needed), just to be sure. There are only two gears, the drive gear and the driven gear. The drive gear is on a imput shaft that also drives the distributor The driven gear I believe does the pumping. I think you will need to take yours apart and see what you need as there are other parts also.
Re: your crank question. Mine did not come with a crank, and I needed to turn #1 cylinder to top dead center to remove/install my hydraulic pump. I used 5/8" rod and a 5/16" pin on the end and I am able to turn the engine to get what I need (with the plugs out).

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]