Farmall & IHC Tractors Discussion Board |
Re: 300U front wheel bearing torque?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on December 10, 2006 at 12:37:26 from (69.178.229.154):
In Reply to: Re: 300U front wheel bearing torque? posted by Allan In NE on December 10, 2006 at 11:46:59:
Allan, Wardner has it RIGHT. Tapered roller front wheel bearings are not commonly pre-loaded, nor are tapered roller bearings used on the rear wheels of pickups or trucks. If you have it jacked up, and wiggle the wheel around, there needs to be a tiny amount of play. If the hubcap is off, and you listen closely, you can hear a little noise from the grease tearing loose as the bearings wiggle. Following the "torque and loosen" procedure, as posted by "Fromjb2" sets the bearings up with that tiny amount of free play. Of course, transmission and differential tapered roller bearings are another matter, and get pre-laded.
Replies:
Home
| Forums
Today's Featured Article -
A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|