|
Farmall & IHC Tractors Discussion Board |
Re: boring the block
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hydro on December 25, 2006 at 08:13:14 from (74.34.95.51):
In Reply to: Re: boring the block posted by north Dakota H puller on December 25, 2006 at 07:55:03:
If you do bore to accept a 3 1/2" sleeve, you will not need to bore any more to install the 3 9/16" thin wall sleeve. It worked well for me. You need to be aware of one more thing. If you bore the H block and use the H head you need to relieve or grind a small area of the combustion chamber to accept the larger pistons. If you use a super H head I don't think you'll have any problems.
Replies:
Home
| Forums
Today's Featured Article -
A Belt Pulley? Really Doing Something? - by Chris Pratt. Belt Pulleys! Most of us conjure up a picture of a massive thresher with a wide belt lazily arching to a tractor 35 feet away throwing a cloud of dust, straw and grain, and while nostalgic, not too practical a method of using our tractors. While this may have been the bread and butter of the belt work in the past (since this is what made the money on many farms), the smaller tasks may have been and still can be its real claim to fame. The thresher would bring in the harvest (and income) once a y
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
